Please note: Only bridge blanks with optional shaping are for sale. No saddle slots or pin holes are cut. String through profile not available. These bridges are intended for bridge pin installation. Why no saddle slots? For optimum intonation, a replacement bridge should be installed after the neck is reset and installed permanently, including at least a 12 fret installed. Then the bridge is located on the top to allow for best saddle slot location (not too close to front edge), then the bridge is glued down, followed by slot cutting. See elsewhere on this website for an easy to make slot cutting jig..
Top bridge is for illustrative purposes only
Indian rosewood bridge blank, with ends thicknessed only - no finishing: $80
Indian rosewood bridge blank finished, sanded smooth, with chamfered edges, rolled front edge, buffed smooth: $125
Brazilian rosewood bridge blank, with ends thicknessed only - no finishing: $150
Brazilian rosewood bridge blank finished, sanded smooth, with champhered edges, rolled front edge, buffed smooth: $200
Top bridge is for illustrative purposes only (rare original Harmony Ovankol bridge)
Finished H1260 bridge in Brazilian
Indian rosewood bridge blank cut to original outline (1/16-inch larger) no profiling no finishing: $100
Indian rosewood bridge blank cut to original outline (1/16-inch larger) With ends profiled only $125
Indian rosewood bridge blank cut to original outline (1/16-inch larger) ends trimmed, front edge rolled, finish sanded and buffed $160
Brazilian rosewood bridge blank cut to original outline (1/16-inch larger) no profiling no finishing: $200
Brazilian rosewood bridge blank cut to original outline (1/16-inch larger) ends profiled only: $225
Brazilian rosewood bridge blank cut to original outline (1/16-inch larger) ends trimmed, front edge rolled, finish sanded and buffed $260
Also note: before gluing, all bridge bottoms must be thoroughly cleaned with acetone. Old Brown Glue recommended.